
Superblade Network Modules User’s Manual
C-4
6. You can now install a double-wide module into the bay. See Figure C-4, Step 6 for
details.
Figure C-4. Step 6
NOTE: This procedure describes modifying three right most single-wide bays
located at the bottom of the inner enclosure. The same procedure applies to the
three right most single bays located at the top of the enclosure, but note that the
horizontal spacers in the bottom bays use a guide pin and are not
interchangeable with the upper bay spacers.
Modules in the upper bays will have their release handles on the bottom, while
modules in the lower bays will have their release handles on the top.
Placing modules in an “upside-down” orientation in an upper-bay (only) does
not affect their operation.
Comentários a estes Manuais