
C-1
Appendix C
Installing Triple Wide Bays
This appendix describes the setup for triple-wide module bays used by the InfiniBand
pass-through module. See Chapter 4 for further details on InfiniBand modules.
C-1 Installing a Triple Wide Module Bay
Use the procedure below for installing a triple-wide module bay in a Superblade chassis.
Installing a Triple-Wide Module Bay
1. Remove the four screws that secure the inner enclosure to the main enclosure.
Slide the inner enclosure outward, depressing the locking tabs on both sides to pull
it completely out.
2. Remove any single-wide modules that are occupying the bays you wish to modify to
a triple-wide bay. See Figure C-1, Step 1 & 2 for details.
Figure C-1. Step 1 & 2
Screws 4pcs
Comentários a estes Manuais