Supermicro AOC-XEH-IN2 Manual do Utilizador descarregar pdf (Página 185)

7-87

Chapter 7: 1/10-Gb Ethernet Switch Firmware

Clicking the BASIC SETTINGS tab brings up the GLOBAL CONFIGURATION page

(Figure 7-75), which can access the MSTP global configuration. The parameters for this

page are shown in Table 7-54.

Table 7-54. Global Configuration Page Parameters

Parameter Description

System Control This parameter Starts or Shutsdown MSTP in the switch.

MSTP Status

This parameter specifies the protocol that can be enabled/disabled at a

global level on the switch using this field.

Compatibility

This parameter allows you to choose to run the protocol in MSTP, RSTP or

an STP compatible version.

Bridge Priority

This parameter specifies the Priority value assigned to the bridge that is

used to select the root bridge.

Transmit Hold Count

This parameter specifies the maximum number of packets that can be sent

in a given interval. This is configured to avoid flooding.

Default Path Cost Version

This parameter allows you to configure the path cost either as a 16-bit

value or a 32-bit value. This is provided mainly for backward compatibility

with STAP.

Maximum Age (Seconds)

This parameter specifies the time period for which the information received

in the RSTP BDPU is valid.

Forward Delay (Seconds)

This parameter specifies how fast a port changes its Spanning state when

moving towards the Forwarding state.

Hop Counts (Seconds)

This parameter specifies the maximum number of bridges that a packet

can cross before it will be dropped, to avoid infinite looping of the packets.

Region Name

This parameter specifies the name for the Region's configuration. By

default, the region name will be equal to the Bridge MAC Address.

Region Version

This parameter specifies the version number of the configuration to be

used.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 391 392

Sem comentários

Supermicro AOC-XEH-IN2 Manual do Utilizador Página 185