
Superblade Network Modules User’s Manual
7-124
Interfaces
Clicking the INTERFACE tab brings up the RIP INTERFACE page (Figure 7-110). The
parameters for this page are shown in Table 7-85.
Figure 7-110. RIP Interface Page
Table 7-85. RIP Interface Page Parameters
Parameter Description
Interface
This parameter specifies the Interface ID for which RIP needs to be
configured.
IP Address This parameter specifies the IP address of the RIP interface.
Status This parameter specifies the admin status of the interface.
Split Horizon
This parameter specifies the operational status of Split Horizon in the
system.
Default Route Installation
This parameter specifies whether Default Route Installation can be done or
not.
Send Version
This parameter allows selecting the RIP packets sent to be compatible to
either RIPV1, RIP1 Compatible or RIPv2.
Receive Version
This parameter is similar to S
END VERSION, but it allows you to choose the
RIP packets to be received as either RIPV1, RIPV2, both RIPv1 and RIPv2
or None.
Route Age Timer
This parameter specifies the time interval after which the routes will be
flushed.
Comentários a estes Manuais