Supermicro 1012C-MRF Manual do Utilizador descarregar pdf (Página 62)

6-2

A+ Server 1012C-MRF User's Manual

Unpacking

The serverboard is shipped in antistatic packaging to avoid static damage. When

unpacking the board, make sure the person handling it is static protected.

6-2 Control Panel

The control panel (located on the front of the chassis) must be connected to the

JF1 connector on the serverboard to provide you with system control buttons and

status indicators. These wires have been bundled together in a ribbon cable to

simplify the connection.

Connect the cable from JF1 on the serverboard to the Control Panel PCB (printed

circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all

excess cabling out of the airﬂ ow path.

The LEDs inform you of system status. See Chapter 3 for details on the LEDs and

the control panel buttons. Details on JF1 can be found in Chapter 5.

6-3 System Fans

The 1012C-MRF employs two sets of 4-cm counter-rotating fans to provide cooling.

Each fan unit is made up of two fans joined back-to-back, which rotate in opposite

directions. This counter-rotating action generates exceptional airﬂ ow and works to

dampen vibration levels. The fans can adjust their speed according to the heat level

sensed in the system, which results in more efﬁ cient and quieter fan operation. Fan

speed is controlled by a setting in BIOS (see Chapter 7). Each fan in a set has its

own separate tachometer.

Note: It is very important that the chassis top cover is properly installed for the

airﬂ ow to circulate properly through the chassis and cool the components.

Figure 6-1. Chassis Views

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 91 92

Sem comentários

Supermicro 1012C-MRF Manual do Utilizador Página 62