Supermicro 1012C-MRF Manual do Utilizador descarregar pdf (Página 35)

Chapter 4: System Safety

5-3

5-3 Processor and Heatsink Installation

Notes:

Always connect the power cord last and always remove it before adding, re-•

moving or changing any hardware components. Make sure that you install the

processor into the CPU socket before you install the CPU heatsink.

If you buy a CPU separately, make sure that you use an Intel-certiﬁ ed multi-•

directional heatsink only.

Make sure to install the serverboard into the chassis before you install the CPU •

heatsinks.

When receiving a serverboard without a processor pre-installed, make sure that •

the plastic CPU socket cap is in place and none of the socket pins are bent;

otherwise, contact your retailer immediately.

Refer to the Supermicro web site for updates on CPU support.•

When handling the processor, avoid placing direct pressure on the label

area of the fan. Also, do not place the serverboard on a conductive sur-

face, which can damage the BIOS battery and prevent the system from

booting up.

Installing the Processors

Begin by removing the cover plate that 1.

protects the CPU. Lift the lever on the

CPU socket until it points straight up.

With the lever raised, lift open the silver

CPU retention plate.

Triangles

Use your thumb and your index ﬁ nger 2.

to hold the CPU. Locate and align pin

1 of the CPU socket with pin 1 of the

CPU. Both are marked with a triangle.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 91 92

Sem comentários

Supermicro 1012C-MRF Manual do Utilizador Página 35