Supermicro CSE-113TQ-563CB Manual do Utilizador descarregar pdf (Página 33)

5-9

Chapter 5 Chassis Setup and Maintenance

Motherboard Installation

Installing the Motherboard

Review the documentation that came with your motherboard. Become familiar 1.

with component placement, requirements, and precautions.

Disconnect the power supply and lay the chassis on a at surface.2.

Open the chassis cover.3.

If necessary, remove the riser card. To do this, remove the two screws hold-4.

ing the card in place and lift the card from the chassis.

As required by your motherboard, install standoffs in any areas that do not 5.

have a permanent standoff. To do this:

A. Place a hexagonal standoff screw through the bottom the chassis.

B. Secure the screw with the hexagon nut (rounded side up).

Lay the motherboard on the chassis aligning the permanent and optional 6.

standoffs with the holes in the motherboard, adding or removing standoffs as

needed.

Secure the motherboard to the chassis using the rounded, Phillips head 7.

screws. Do not exceed eight pounds of torque when tightening the mother-

board.

Secure the CPU(s), heatsinks, and other components to the motherboard, 8.

chassis, and/or backplane as needed.

Figure 5-8: Securing the Motherboard to the Chassis

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

Sem comentários

Supermicro CSE-113TQ-563CB Manual do Utilizador Página 33