Supermicro CSE-113TQ-563CB Manual do Utilizador descarregar pdf (Página 28)

SC113 Chassis Manual

5-4

Warning: Except for short periods of time (swapping hard

drives), do not operate the server with the hard drives empty.

Figure 5-3: Removing the Dummy Drive from the Hard Drive Carrier

Installing a Hard Drive into a Drive Carrier

Remove the dummy drive, which comes pre-installed in the drive carrier, by 1.

removing the screws securing the dummy drive to the carrier. Note that these

screws cannot be reused on the actual 2.5" hard drive.

Insert a drive into the carrier with the PCB side facing down and the connec-2.

tor end toward the rear of the carrier.

Align the drive in the carrier so that the screw holes of both line up. Note that 3.

there are holes in the carrier marked “SATA” to aid in the correct positioning.

Secure the drive to the carrier with four M3 screws. These screws are in-4.

cluded in the chassis accessory box.

Insert the drive carrier into its bay, keeping the carrier oriented so that the 5.

hard drive is on the top of the carrier and the release button is on the right

side. When the carrier reaches the rear of the bay, the release handle will

retract.

Push the handle in until it clicks into its locked position.6.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 67 68

Sem comentários

Supermicro CSE-113TQ-563CB Manual do Utilizador Página 28