Supermicro SYS-8016B-6F Manual do Utilizador descarregar pdf (Página 42)

5-10

SUPERSERVER 8016B-6F/8016B-TF User's Manual

RDIMM Support POR on the 7500 Series Processor Platform

DIMM Slots

per DDR

Channel

DIMMs

Populated

per DDR

Channel

RDIMM Type

(RDIMM: Reg.=

Registered)

POR Speeds (in

MHz)

Ranks per DIMM

(Any Combination)

1 1 Reg. ECC DDR3 800,978, 1066 SR, DR, or QR

2 1 Reg. ECC DDR3 800,978, 1066 SR, DR, or QR

2 2 Reg. ECC DDR3 800,978, 1066 Mixing SR, DR, QR

Population Rules:

1. Any combination of x4 and x8 RDIMMs with 1 Gb or 2 Gb DRAM density are supported.

2. Populate DIMMs starting with DIMM1A.

3. When mixing QR with SR or DR on the same DDR channel, put the QR in DIMM1A ﬁ rst.

Notes and Restrictions

Only DDR3-1066 RDIMMs are validated at speeds of 800, 978, 1066 MHz.•

For the memory modules to work properly, please install DIMM modules in pairs •

(with an even number of DIMMs installed).

All channels in a system will run at the fastest common frequency.

•

5-7 Adding PCI Add-On Cards

The 8016B-6F/8016B-TF can accommodate one PCI-Express 2.0 x16 card with the

use of the RSC-RR1U-E16 riser card inserted into the PCI-E x16 slot.

Installing an Add-on Card

Begin by removing the PCI slot shield for the slot you wish to populate.1.

Fully seat the card into the riser card slot, pushing down with your thumbs 2.

evenly on both sides of the card.

Finish by using a screw to secure the top of the card shield to the chassis. 3.

The PCI slot shields protect the serverboard and its components from EMI

and aid in proper ventilation, so make sure there is always a shield covering

each unused slot.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 105 106

Sem comentários

Supermicro SYS-8016B-6F Manual do Utilizador Página 42