Supermicro SuperServer 8047R-TRF+ Manual do Utilizador descarregar pdf (Página 75)

Chapter 6: Advanced Chassis Setup

6-7

Figure 6-7: Add a Hard Drive to the Drive Tray

Hard Drive

Hard Drive Tray

Adding Peripheral Drives (DVD-ROM, CD-ROM, Floppy Drive, etc.) to the

Drive Trays

1. Open the chassis cover.

2. Locate the drive tray release tab for the slot you want to place the peripheral

drive (see Figure 6-6).

3. Push the drive tray toward the front of the chassis.

4. Remove the hard drive tray rails from the hard drive tray. To do this, you must

remove two screws from each side.

5. Attach the rails to a DVD-ROM, CD-ROM, ﬂ oppy drive, or other peripheral.

The rails should ﬁ t any standard sized peripherals (Figure 6-8).

6. Slide the peripheral into the chassis until the tray clicks into place.

7. Repeat these steps for each hard drive tray.

Caution! Enterprise level hard disk drives are recommended for use in

Supermicro chassis and servers. For information on recommended HDDs,

visit the Supermicro Web site at http://www.supermicro.com/products/nfo/ﬁ les/

storage/SAS-CompList.pdf

Caution: Use caution when working around the backplane. Do not touch the backplane

with any metal objects and make sure no ribbon cables touch the backplane or obstruct

the holes, which aid in proper airﬂ ow.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 121 122

Sem comentários

Supermicro SuperServer 8047R-TRF+ Manual do Utilizador Página 75