Supermicro SuperServer 8047R-TRF+ Manual do Utilizador descarregar pdf (Página 44)

5-4

SUPERSERVER 8047R-TRF+/7RFT+ USER'S MANUAL

5-4 Installing the Processor and Heatsink

Caution! Avoid placing direct pressure to the top of the processor package. Always

remove the power cord ﬁ rst before adding, removing or changing any hardware

components.

Caution: The Quad MB (4 CPU socket) was recommended to install all the 4 CPU to

make sure every function can work properly. Some MB function may not work under

the 1/2/3 CPU conﬁ guration. For example: PCIE slot, on board LAN port and others.

Notes:

• Always connect the power cord last and always remove it before adding,

removing or changing any hardware components. Make sure that you install the

processor into the CPU socket before you install the CPU heatsink.

• If you buy a CPU separately, make sure that you use an Intel-certiﬁ ed multi-

directional heatsink only.

• Make sure to install the serverboard into the chassis before you install the CPU

heatsinks.

• When receiving a serverboard without a processor pre-installed, make sure that

the plastic CPU socket cap is in place and none of the socket pins are bent;

otherwise, contact your retailer immediately.

• Refer to the Supermicro web site for updates on CPU support.

OPEN 1st

WARNING!

Press down on

load lever labeled

'Open 1st'.

Installing the LGA2011 Processor

1. There are two load levers on the LGA2011 socket. To open the socket cover,

ﬁ rst press and release the load lever labeled 'Open 1st'.

OPEN 1st

WARNING!

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 121 122

Sem comentários

Supermicro SuperServer 8047R-TRF+ Manual do Utilizador Página 44