Supermicro A+ Server 1020A-T, Beige Manual do Utilizador descarregar pdf (Página 41)

Chapter 5: Advanced Serverboard Setup

5-7

5-5 I/O Ports

The I/O ports are color coded in conformance with the PC 99 speciﬁ cation. See

Figure 5-3 below for the colors and locations of the various I/O ports.

Figure 5-3. Rear Panel I/O Ports

5-6 Installing Memory

CAUTION

Exercise extreme care when installing or removing memory modules

to prevent any possible damage.

1. Insert each memory module vertically into its slot, paying attention to the notch

along the bottom of the module to prevent inserting the module incorrectly (see

Figure 5-4). See support information below.

2. Gently press down on the memory module until it snaps into place.

Note: each processor has its own built-in memory controller, so CPU2 DIMMs can-

not be addressed if only a single CPU is installed. 128 MB, 256 MB, 512 MB, 1

GB, 2 GB* and 4 GB* memory modules are supported.

*With Opteron 246 C-stepping CPUs and above.

Support

The H8DAR-T supports single or dual-channel, registered ECC DDR400/333/266

SDRAM.

Both interleaved and non-interleaved memory are supported, so you may populate

any number of DIMM slots (see note on previous page). The CPU2 DIMM slots

can only be accessed when two CPUs are installed (however, the CPU2 DIMM slots

are not required to be populated when two CPUs are installed).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 99 100

Sem comentários

Supermicro A+ Server 1020A-T, Beige Manual do Utilizador Página 41