Supermicro SYS-6028R-T Manual do Utilizador descarregar pdf (Página 53)

Chapter 5: Advanced Serverboard Setup

5-7

1. Unplug the power cord from the power supply.

2. Unscrew and remove the heatsink screws in the sequence shown in the

picture below.

3. Hold the heatsink and gently wiggle it to loosen it from the CPU. (Do not use

excessive force when doing this!)

4. Once the heatsink is loosened, remove it from the CPU.

5. Clean the surface of the CPU and the heatsink to get rid of the old thermal

grease. Reapply the proper amount of thermal grease before you re-install

the heatsink.

Removing the Heatsink

Caution: We do not recommend removing the CPU or the heatsink. If you do need

to remove the heatsink, please follow the instructions below to prevent damage to the

CPU or other components.

Installing a CPU Heatsink

1. Place the heatsink on top of the CPU so that the four mounting holes are

aligned with those on the retention mechanism.

2. Screw in two diagonal screws (i.e. the #1 and the #2 screws) until just snug

(do not over-tighten the screws, which may damage the CPU.)

3. Finish the installation by fully tightening all four screws.

Screw #1

Screw #2Screw #3

Screw #4

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 127 128

Sem comentários

Supermicro SYS-6028R-T Manual do Utilizador Página 53