Supermicro SuperStorage Server 2027R-E1R24L Manual do Utilizador Página 71
- Página / 131
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
5-22
SUPERSTORAGESYSTEM 2027R-E1R24L User's Manual
Universal Serial Bus (USB)
There are four Universal Serial Bus
ports (USB0/1/2/3) located on the
I/O panel. In addition, there is one
Type A port (USB6) and four head-
ers (USB4/5/8/9) located on the
serverboard. The headers can be
used to provide front side USB access
(cables not included). See the table on
the right for pin defi nitions.
USB Header (USB4/5/8/9/6)
Pin Defi nitions
USB4/6
Pin # Defi nition
USB5/7
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 N/A 5 Key
SGPIO Headers
The SGPIO (Serial General Purpose
Input/Output) headers are used to
communicate with the enclosure
management chip on the backplane.
See the table on the right for pin
defi nitions.
SGPIO Header
Pin Defi nitions
Pin# Defi nition Pin Defi nition
1NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
NC = No Connection
Back Panel USB
(USB 0/1/2/3)
Pin# Defi nitions
1 +5V
2 PO-
3 PO+
4 Ground
5 N/A
Overheat LED/Fan Fail (JOH1)
The JOH1 header is used to connect
an LED to provide warning of chassis
overheating or fan failure. This LED
will blink to indicate a fan failure. Refer
to the tables on right for LED status
and pin defi nitions.
Overheat LED
Pin Defi nitions
Pin# Defi nition
1 5vDC
2 OH Active
OH/Fan Fail LED
States
State Message
Solid Overheat
Blinking Fan Fail
DOM Power Connector
A power connector for SATA DOM
(Disk On Module) devices is located at
JSD1. Connect an appropriate cable
here to provide power support for your
Serial Link DOM devices.
DOM PWR
Pin Defi nitions
Pin# Defi nition
1 +5V
2 Ground
3 Ground
- SUPER 1
- Manual Revision 1.0 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 7 BIOS 8
- Chapter 1 10
- Introduction 10
- 1-2 Serverboard Features 11
- 1-3 Server Chassis Features 12
- System Block Diagram 13
- X9DRD-7(J)LN4F 14
- 1-4 Contacting Supermicro 15
- Chapter 2 16
- Server Installation 16
- Warnings and Precautions! 17
- Rack Mounting Considerations 18
- Inner Rails 21
- Standard Chassis Installation 23
- Chapter 3 26
- System Interface 26
- Power Fail 27
- Overheat/Fan Fail 27
- 3-4 Drive Carrier LEDs 28
- Chapter 4 30
- ﺔﻴﺋﺎﺑﺮﻬﻜﻟﺍ 32
- Installation Instructions 33
- 250 V, 20 A 34
- Power Disconnection Warning 35
- ילמשח קותינ ינפמ הרהזא 36
- Equipment Installation 37
- Restricted Area 38
- Battery Handling 39
- Redundant Power Supplies 41
- Backplane Voltage 42
- Product Disposal 44
- רצומה קוליס 45
- Power Cable and AC Adapter 47
- (UL/CSA ﻞﻤﺤﺗ ﻲﺘﻟﺍﺔﻣﻼﻋ ) 48
- Chapter 5 50
- Advanced Serverboard Setup 50
- • Control Panel cable (JF1) 51
- 2 1 52
- 20 19 52
- OPEN 1st 53
- WARNING! 53
- 5-5 Installing Memory 58
- DIMM Module Population Tables 59
- 1 CPU, 2 DIMMs 61
- 1 CPU, 5-8 DIMMs 61
- 1 CPU, 4 DIMMs 61
- Rev. 1.01 62
- 5-6 Adding PCI Add-On Cards 63
- 5-7 Serverboard Details 64
- LED Description State 66
- 5-8 Connector Defi nitions 67
- BMC Enable 74
- Jumper Settings 74
- Pins 1-2 BMC Enable 74
- Pins 2-3 Normal (Default) 74
- 5-10 Onboard Indicators 76
- 5-11 SATA Ports 77
- 5-12 Installing Software 78
- SuperDoctor III 79
- LTUM ATTERY 81
- ATTERY OLER 81
- Chapter 6 82
- Advanced Chassis Setup 82
- Hard Drives (24)Control Panel 83
- I/O Ports (see Figure 5-2) 83
- Release Tab 84
- Remove this screw 84
- (if necessary) 84
- 6-4 System Cooling 85
- Air Shrouds 86
- Accessing the Drive Bays 88
- 6-5 Power Supply 91
- Chapter 7 94
- 7-2 Main Setup 95
- XBoot Feature 97
- • Type of CPU 98
- • CPU Signature 98
- • Microcode Patch 98
- • CPU Stepping 98
- • Maximum / Minimum CPU Speed 98
- XChipset Confi guration 103
- XNorth Bridge 103
- XQPI Confi guration 104
- XDIMM Information 105
- XSouth Bridge Confi guration 106
- XSATA Confi guration 107
- XPCIe/PCI/PnP Confi guration 108
- XSuper IO Confi guration 110
- XSerial Port 1 Confi guration 110
- XSerial Port 2 Confi guration 110
- XConsole Redirection Settings 111
- XACPI Settings 114
- XME Subsystem 116
- XNIC Confi guration 116
- 7-4 Event Logs 118
- 7-5 IPMI 120
- BMC Network Confi guration 121
- 7-6 Boot 122
- 7-7 Security 123
- 7-8 Save & Exit 124
- Appendix A 126
- BIOS Error Beep Codes 126
- Appendix B 128
- System Specifi cations 128
- Regulatory Compliance 130
Manuais e produtos relacionados com Servidor barebones Supermicro SuperStorage Server 2027R-E1R24L
(92 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais