Supermicro 8046B-TRF Manual do Utilizador descarregar pdf (Página 18)

2-4

SUPERSERVER 8046B-6RF/8046B-TRF User's Manual

2-4 Installing the System into a Rack

This section provides information on installing the system into a rack unit. Rack

installation requires the use of the optional rackmount kit If the system has already

been mounted into a rack or if you are using it as a tower, you can skip ahead to

Sections 2-5 and 2-6. There are a variety of rack units on the market, which may

mean the assembly procedure will differ slightly. The following is a guideline for

installing the server into a rack with the rack rails provided in the rackmount kit.

You should also refer to the installation instructions that came with the rack unit you

are using. Note: The outer rail is adjustable from 26" to 38.25".

Removing the Chassis Cover and Feet

The SC748 chassis is shipped with the chassis cover and feet pre-installed. Both

the feet and cover must be removed for before installing the rails.

Removing the Chassis Top Cover

Locate the chassis cover lock (blue lever) at the rear of the chassis cover.1.

Slide the chassis cover lock to the right and push chassis cover forward.2.

Lift the chassis top cover off the chassis.3.

Removing the Chassis Feet

Place the chassis on its side with the chassis side cover facing upward.1.

Remove the screw holding the chassis foot in place.2.

The foot lock is a tab located in the center of the foot that prevents the foot 3.

from sliding. Using a ﬂ at head screwdriver, gently lift the foot lock upward

and slide the foot toward the rear of the chassis.

Repeat steps 2 and 3 with each remaining foot.4.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 103 104

Sem comentários

Supermicro 8046B-TRF Manual do Utilizador Página 18