Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Manual do Utilizador descarregar pdf (Página 31)

100

101

Chapter 3: Setup and Installation

5. Push the release handle to the closed position.

Removing a Switch Module

1. Pull out the release handle to the open position.

2. Pull the module out of the bay.

3. Replace immediately with another module or with a dummy module cover to

maintain airflow integrity.

Figure 3-2. Blade Enclosure with 1/10 Gbps Switch Modules Installed

NOTE: After the module has been installed and the handle locked, it will turn on

and a POST test will run to verify it is working properly. If there are no problems

the blue Init. OK LED on the module will illuminate and you will see an OK

under I

NITIATED in the GBE SWITCH screen of the management software utility.

NOTE: If the module is installed in a top bay it must be positioned upside-down.

SBM-GEM-X2C

Switch Modules

SBM-XEM-002 Pass-Through Module

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 333 334

Comentários a estes Manuais

Sem comentários

Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Manual do Utilizador Página 31

Comentários a estes Manuais