Supermicro CSE-942I-R760 Guia de Instalação

1.0® SUPERSC942 CHASSISINSTALLATION GUIDESC942S-600 SC942i-600/550

SUPER SC942 Chassis User's Guide2-63. Slide the side cover back to the proper position. Make sure that the lockbracket is easily accessible from

2-7Chapter 2: Installation ProceduresF. Removing the Front Side Cover to Access the Drives(You do not need to remove the front bezel to access the d

SUPER SC942 Chassis User's Guide2-84. Push on the open side of cover to completely remove it from the chassis.(*Do not swing or pull the front co

2-9Chapter 2: Installation ProceduresSection 2: Installing the SC942 as a RackmountG. Rackmount Rail Kit: CSE-PT26(* CSE-PT26 Sold separately.)CSE-PT

SUPER SC942 Chassis User's Guide2-10H. Removing the Top Chassis Cover and Chassis Feet to Install as RackmountProcedures1. Remove the side cover

2-11Chapter 2: Installation ProceduresAfter you have removed chassis feet from the chassis, you can now attachchassis ears to the chassis.Procedures1.

SUPER SC942 Chassis User's Guide2-12Press the Locking TabJ. Installing Chassis RailsAfter you have attached the chassis ears to the chassis, you

2-13Chapter 2: Installation ProceduresK. Rack InstallationAfter you have installed the inner rails and chassis ears to the chassis, youare ready to in

SUPER SC942 Chassis User's Guide2-145. Align brackets flush against the racks and tighten two screws throughthe holes of the rack (as shown below

2-15Chapter 2: Installation Procedures7. To mount the SC942 on the rack, first you need to align both of the innerslides that are attached on the SC94

SUPER SC942 Chassis User's Guide1-2Table of ContentsChapter I: Unpacking and Check Lists ...1-3Chapter 2: Instal

SUPER SC942 Chassis User's Guide2-169. Secure the SC942 by tightening the screws on the sides of the SC942 asshown above.screws

Mobile RackCSE-M35S/CSE-M35T1User's GuideRev. 1.0Appendix A

SUPER SC942 Chassis User's GuideA-2CSE-M35S/CSE-M35T1Supermicro’s CSE-M35S/CSE-M35T1 Mobile Rack Series offers the cuttingedge technology with gr

A-3Appendix A: SUPER CSE-M35S/CSE-M35T1 User's GuideB. Technical Specifications Chassis supported:SC762, SC830, SC942 Occupancy Three (3) 5.25&

SUPER SC942 Chassis User's GuideA-4C. Jumper SettingsC-1. Jumper Settings for the CSE-M35S (SCSI):Location of JumpersJP29JP21JP30JP18JP24Pin 1Pin

A-5Appendix A: SUPER CSE-M35S/CSE-M35T1 User's GuideC-2. Jumper Settings for the CSE-M35T1 (SATA):Location of JumpersJP28JP25JP18Channel #1Channe

SUPER SC942 Chassis User's GuideA-6D-1. Accessing Hot Swappable Drives:1.Push the release button located beside the drive LEDs (as shownbelow:)2

A-7Appendix A: SUPER CSE-M35S/CSE-M35T1 User's GuideD-2. Accessing the Exhaust Fan:1.Push the tabs located on both sides of the unit (as shown b

SUPER SC942 Chassis User's GuideA-8D-3. Accessing the Drive Backplane:1. Unscrew the screw located on the side of the unit (as shownbelow:)2. P

Power Supply SpecificationsAppendix BPlease refer to the following table for Power Supply Specifications:B-1Power Supply Spec SC942S-600 SC942i-600

1-3Chapter 1: Unpacking and Check Lists Chapter 1- Unpacking and Check Lists1-A. The SC942S-600 chassisThe SC942S chassis contains the following:One

B-2NotesAppendix B: Power Supply Specifications

SCSI (Super) GEM Driver Installation Instructions forWindows OSAppendix CPlease refer to the following instructions to install the SCSI GEMDriver fo

C-25) At the first prompt, choose “Display a list of known device driversfor the device so that I can choose a specific driver” and click "Next&q

SUPER SC942 Chassis User's Guide1-41-B. The SC942i chassisThe SC942i chassis contains the following:Eight (8) 5.25" peripheral drive baysOne

2-1Chapter 2: Installation ProceduresA. Removing the Side Cover of the SC942 ChassisBefore installing any components, replacing chassis fans or acce

SUPER SC942 Chassis User's Guide2-2B. Removing the SCSI Drive Trays (*SC942S)Procedures1.Pull out the SCSI Drive Trays located on the front side

2-3Chapter 2: Installation ProceduresC. Removing the Rear Exhaust Fan and Installing the Motherboard(You will need to remove the rear exhaust fan befo

SUPER SC942 Chassis User's Guide2-4D. Removing Components from and Installing Devices into the 5.25" Drive BaysAfter removing the side

2-5Chapter 2: Installation ProceduresE. Installing the Rear Chassis LockFollow the procedures listed below to install the Rear Chassis Lock.Procedures