Supermicro CSE-503L-200B Manual do Utilizador descarregar pdf (Página 26)

SC503 Chassis Manual

5-6

Add-on Card/Expansion Slot Setup

SC503 chassis includes an I/O slot for the optional add-on card. A full-height, half-

length PCI add-on card is supported. A riser card is required in order to adapt the

add-on card to the 1U chassis. For additional information on add-on cards and

risers cards, refer to the Supermicro website at www.supermicro.com

Figure 5-5: Installing the Add-on Card

Disconnect the chassis from the power source.1.

Remove the screws holding the add-on card clip and the dummy bracket 2.

which covers the openings in the back of the chassis.

Remove the add-on card clip and the dummy plate from the chassis. 3.

Outside of the chassis, insert the add-on card into the riser card.4.

Insert the assembled add-on card and riser card into the expansion slot inside 5.

the chassis, carefully aligning the plate of the add-on card with the openings

in the back of the chassis.

Replace the add-on card clip and screw it onto the chassis to hold the add-on 6.

card in place.

Replace the chassis cover.7.

Add-on Card

Bracket Clip

Bracket

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

Sem comentários

Supermicro CSE-503L-200B Manual do Utilizador Página 26